Product Range

 
 
Slings
Links & Rings
Wire Rope
Wire Rope Thimbles
Clamps
Ropes
Shackles
Hooks
Sockets
Blocks
Swivel
Hoists
Wire Associated Accessories
Winch & Other Machines
Other Types of Chains
  Turn Buckle
  Multiple Leg Slings with Oval Links
  Rigging / Bottle Screw
  Cable Grip
  Assorted Stainless Steel Products
  Ratchet Lashing System
 
     
     
  super - 8 Chain Hoist

WS8CH 01 WS8CH 02 WS8CH 03 WS8CH 04
 

Ultra S-series
The ULTRA S- Series Chain Hoist is a portable lifting device easily operated by hand chain. It is suitable for use in factories, mines, farms, construction sites, wharves, docks and warehouses for installation of equipment, as well as for loading and unloading goods. It is specially advantageous for lifting work in the open air and places where no power supply is available.
ULTRA S- Series Chain Hoist has some improvements in construction design and using material and manufacturing process. It sells well at home as the construction of materials JIS standards and in light weight.
The chain Hoist can be attached to a trolley of any as a traveling chain Hoist. It is suitable to monorail overhead conveying system, hand traveling crane and jib crane.

 
WS8CH 05 WS8CH 06 WS8CH 07 WS8CH 08
 

OPERATION INSTRUCTIONS
Before lifting inspect carefully the hooks, the load chain, the brake device and lubrication of the block. For safe operation you must keep six rules as following.
1) Don't lift load exceeding the rated capacity ofthe chain block.  
2) Don't use the block chain as a sling  
3) Don'tusewhenthechainiskinking.
4) To avoid accidents working or passing under a lifting load is strictly for bidden.   5) In case of the hand chain fails to move. Don't use undue force. Stop operation and proceed inspection ofthe chain block    6)  Only use to lift vertically, do not use to drag loads.

MAINTENANCE
After operation, clean the chain block from dirt and keep it in a dry place from rust and corrosion.
Clean the chain block annually by purging the parts in kerosene and supply grease to them. It is advisable that the cleaning work should be done by skilled
hands.
"0" marks on the two disk gears should be aligned.
Stick the rollers of both left and right bearings to the inner race of the bearings on the chain sprocket shaft journal, and then put then into outer race of the
bearing on the side plates.
After cleaning and repair the chain block should be subjected to non-load and heavy load tests. If it works normally put it into operation.
For convenience of maintenance and dismantling. One of the links of the hand chain is open.